Basic Bow Mount - Powder Coated Black
This mount is the most basic for the bow of your boat or for mounting on a flat console.
Offers a raise of 90mm and suitable to comfortably carry units up to 5kg (Tested and Tried)
The offset angle is 43.5 degrees and is designed for boats with ample space between trolling motor pedal and gunnel keeping the graph lower to the deck.
Please note it does not offer enough clearance to fit your foot under mount and on the pedal.
Before you order please make sure of the measurements.
No mounting hardware included with this mount.
Fitment requirements - Drill, tools appropriate to your bolts and deck screws & marker pen
Gimbal to mount:
4mm steel drill bit (Check your Gimbal)
6 x 4mm x 16mm Stainless steel bolts, locknuts and fender washer. (Some brands have higher bases, so please measure)
Mount to Deck:
5mm steel drill bit
6 x either 5mm self tapping stainless steel screws of minimum 40mm lenght or 5mm Stainless Steel bolts, locknut and fender washers (highly recommended to use bolts)
Make sure your trolling motor (if applicable) can be deployed before mounting.
When drilling directly into fiberglass, use slow speed and drill in reverse to penetrate past gel-coat. It is recommended to stick duck-tape to the fiberglass and mark on the tape. The tape also helps prevent the drill from "walking".
